Huatao Technical News

Helicoid vs Sectional Screw Flighting: Which One for Abrasive Materials?

Date Issued:2026-11-17

Helicoid vs Sectional Screw Flighting: Which One for Abrasive Materials?

 

Choose sectional flighting when abrasion is the dominant wear mode. Choose helicoid when abrasion is light to moderate and the size is standard. The distinction rests on three verifiable differences: edge thickness after forming, available plate grades, and whether a worn section can be replaced independently.

Difference 1: What Happens to the Outer Edge

Helicoid flighting is cold-rolled from strip. The outer edge compresses during forming and finishes thinner than the root—typically the inner edge ends up roughly twice the outer-edge thickness.Abrasive wear is concentrated at the periphery, where the blade runs closest to the trough and sees the highest sliding speed. A thinner rim therefore means less sacrificial material precisely where it is needed most.

Sectional flighting is pressed from plate or machined as individual turns. Thickness remains uniform across the full blade width. A 16 mm plate produces a 16 mm rim, not a thinned edge.

Difference 2: Material Grade Availability

Continuous rolling constrains the steel grades that can be formed economically. Sectional fabrication is compatible with Hardox, AR plate and manganese steel, allowing the flight to be specified in a grade whose hardness and wear resistance are through-thickness rather than surface-only. In alumina, fly ash, glass cullet and cement clinker, this is frequently the deciding factor.Helicoid’s cold-rolled surface hardening provides useful but finite resistance for moderate abrasion.

Difference 3: Maintenance Access

A sectional screw can be designed with replaceable bolted segments. When one zone wears through, that section is swapped without removing the shaft or cutting out the entire helix. For continuous helicoid, replacement is usually a full-helix or hard-facing operation. In abrasive plants where unplanned downtime carries a high hourly cost, sectional modularity changes the economics beyond the purchase price.

Selection Summary

Sectional: highly abrasive material; Hardox or manganese required; thick plate, large diameter or non-standard pitch; replaceable maintenance preferred.
Helicoid: light to moderate abrasion; standard CEMA size; first cost and continuous production favored.

Contact: Lucy Chai | Lucy.chai@huataogroup.com | www.refinerdisc.com | WhatsApp: +86 15373883537

 #ScrewFlight #SpiralBlade #MetalForming #HUATAO #auger #screwconveyor #feedmixer #AbrasiveWear

 
 
* E-mail :

can not be empty

* Question :

can not be empty

Related News